Description
Crankshaft with Italkit machined connecting rod for Aprilia RS 125 / Rotax 122 2T.
Italkit for Aprilia RS 125 / Rotax 122 2T.
It is machined with high quality materials preserving all the original measurements, obtaining a higher rigidity and hardness against high RPM.
¡Attention! You must carry out the balancing checks before mounting on the engine, since the manufacturers, any balancing failure located after the mounting, deny warranty.
Attention We recommend you to check the balance before mounting on the engine.
Additional Information
| SKU: | CB.01.122 |
| Original pin?: | Yes |
| Pin Measure: | 20mm |
| Small End Bearing Measure: | 15x19x20mm |
| Original Course?: | Yes |
| Course: | No |
| Original Connecting Rod?: | Yes |
| Connecting Rod: | 110mm |
| Ø Ignition Axis: | No |
| Ø Drive shaft: | No |
| Product Type: | Crankshaft |
Product Questions
You must be logged in to ask questions.
No questions yet. Be the first to ask the question!
Good for
| Make | Model |
|---|---|
| Make | Model |
| Aprilia | RS 125 |
| Aprilia | ROTAX 122 |
| Aprilia | RS 125 EXTREMA |
| Aprilia | RS Pista 125cc (92-12) |