Crankshaft with Italkit machined connecting rod for Aprilia RS 125 / Rotax 122 2T.
Italkit for Aprilia RS 125 / Rotax 122 2T.
It is machined with high quality materials preserving all the original measurements, obtaining a higher rigidity and hardness against high RPM.
The fabric is machined subjected to térmical treatment processes that make it more resistant to fatigue and high temperatures. This means they can withstand higher revolutions and loads without deforming or breaking.
.
¡Attention! You must carry out the balancing checks before mounting on the engine, since the manufacturers, any balancing failure located after the mounting, deny warranty.
Attention We recommend you to check the balance before mounting on the engine.
SKU: | CB.01.122R |
Original pin?: | Yes |
Pin Measure: | 20mm |
Small End Bearing Measure: | 15x19x20mm |
Original Course?: | Yes |
Course: | No |
Original Connecting Rod?: | Yes |
Connecting Rod: | 110mm |
Ø Ignition Axis: | No |
Ø Drive shaft: | No |
Product Type: | Crankshaft |
Make | Model |
---|---|
Make | Model |
Aprilia | RS 125 |
Aprilia | ROTAX 122 |
Aprilia | RS 125 EXTREMA |
Aprilia | RS Pista 125cc (92-12) |
We request your permission to gather statistics regarding your use of this page, in compliance with the Royal Decree 12/2012. If you continue using this page you agree to the use of cookies. +Info