"One finger" Pro clutch Vespa small frame Egig

"One finger" Pro Vespa small frame Egig clutch.

• 5 discs, cork/carbon mix, thickness 1.9mm
• 4 steel intermediate plates, thickness 0.8mm
• pressure plate with bearing
• compatible with original type basket
• 500ml SAE 30

Pay special attention if your basket uses screws and the heads are positioned inside, as they could rub.

• 6 springs: 28hp and 26nm
• 8 springs: 35hp and 30nm

The manufacturer recommends clutch rods with a short cam, as they have a greater travel, which means the clutch separates completely.

Important: the nut and washer together must not measure more than 7mm, and the primary shaft thread must not protrude from the nut once installed.

The clutch cover gasket must measure 0.2mm, original type, to avoid operational issues.